Maintenance Manual for J2 Sedan
Service
16
②
Take off air filter element.
2) Inspection After Dismantlement
■
The air filter must be regularly cleaned or replaced
according to recommended schedule. Please
refer to “Regular Service”.
■
Blow back of air filter element with compressed air until nothing can be blown away.
3) Installation
Install with steps contrary to dismantlement.
7. Replacement of Engine Oil
Attention:
■
Be careful not to be scalded since oil temperature is high.
■
Long-time direct contact between skin and the used oil should be avoided. In case contacted,
wash with soap or detergent thoroughly as soon as possible.
1) Warm up the engine, and check for any oil leakage in the engine compartment. Refer to “Leakage of
engine oil”.
2) Stop engine and wait for ten minutes.
3) Loosen engine oil filler cap, and then remove the oil drain screw plug.
4) Discharge engine oil.
5) Install the oil drain screw plug with new gasket.
Attention:
■
Any dirt such as iron debris on oil drain screw plug must be cleaned, and new gaskets
should be installed.
■
Tightening torque of oil drain bolt: 34-44 N·m.
6) Refill new oil.
For specification and viscosity of engine oil, please refer to “Recommended Oil and Lubricant”.
■
Engine oil quantity: 3.8L
Attention:
■
During the filling of engine oil, please do not remove oil gage.
■
The filling amount of engine oil may vary according to oil temperature and oil drain time.
Quantity above is for reference only.
Fig. 2.2.006
