Maintenance Manual for J2 Sedan
Mechanical Part of Engine
120
5)
Disconnect the fuel pipe joint 1 (at fuel pump
side), joint 2 (at fuel filter side) and
grounding end 3 of fuel filter.
Attention:
The fuel filter should be wrapped up with towel
or equivalent, so as to avoid injection of
residual fuel.
Disconnect joint with following methods:
■
Hold the side edge of joint and press the
raised position of joint to pull out the fuel
pipe.
■
If the joint attaches to the resin pipe, push and
pull the joint for several times until it moves,
and then pull out the joint.
Attention:
■
The joint can not be disconnected when the
raised position is fully pressed down. Do not
excessively distort the joint.
■
Do not disconnect the joint with any tool.
■
Prevent the resin pipe from being heated. Special attention must be paid when welding around
the resin pipe.
■
Prevent the resin pipe from contacting acidic fluid such as electrolyte of battery.
■
Do not bend or distort the resin pipe during installation and dismantlement.
■
To keep the connection clean and prevent from damage and foreign substance, please fully cover
them with plastic bag or equivalent.
6) Take off the fuel filter and fuel pipe.
2. Installation
Be aware of following precautions to install with steps contrary to dismantlement.
3
2
Fig. 1.4.008
1
Fig. 1.4.007
Fig. 1.4.009