Chapter 2: Hardware Installation
Figure 2-11: Adjusting Support Bracket Length
Step 5.
Pass two (2) M5 x 10mm Truss Head screws through the
middle two (2) screw holes on front and rear sides of the
support brackets, and then fasten the screws. There are
cage nuts behind the screw holes.
Figure 2-12: Installing the Support Brackets
Step 6.
Attach the inner brackets to the sides of the subsystem
chassis by fastening five (5) #6-32 x 6mm Flat Head
screws through the screw holes on the inner brackets to
the chassis.(See the figure below)
NOTE:
The inner brackets will project 75mm from the rear end of the
chassis.
2-13
