Chapter 2: Hardware Installation
Figure 2-21: Opening the Drive Tray Front Flap
Step 3.
Align the drive tray with the drive bay
into which you
wish to insert it, and then slide it in. This should be done
smoothly and gently. (See the figure below)
Figure 2-22: Installing a Drive Tray
Step 4.
Close the front flap.
Close the front flap properly so
that the connector at the back of the hard drive can be
firmly connected to the corresponding connector on the
backplane board. (See the figure below) If the front flap
is not closed properly, the connection between the hard
drive and the subsystem will not be secure.
Figure 2-23: Closing the Front Flap
Step 5.
Lock the front flap into place
by turning the rotary
bezel lock using a small size flathead screwdriver until
the groove on its face is pointing down (vertical
orientation). (See the figure below)
2-19
