Chapter 5: Subsystem Maintenance and Upgrading
Figure 5-28: Removing the MUX Kit Retention Screws
Step 4.
Orient the replacement MUX kit
and align its mounting
holes with those on the drive tray. The SATA connector
should face the front side and the SAS connector should
face the rear side.
SAS and SATA interfaces look similar. A SAS connector
has pins on both sides.
Step 5.
Secure the MUX kit
by driving two (2) retention screws
from the bottom of the drive tray.
Step 5.
Re-install the hard drive
, once the new MUX kit has
been installed on the drive tray. Please refer to the
complete procedures in
Section 2.7.3
.
Step 6.
Re-insert the drive tray into the subsystem
, after the
hard drive has been placed in the drive tray. Please refer
to
Section 2.8
for detailed instructions.
5-23
