EonStor S12F-R1432/G1433 Installation and Hardware Reference Manual
•
Secure installation:
When you re-install the controller module
after replacing the DIMM module, make sure that the new DIMM
module is firmly in place, or the subsystem will not be able to run.
5.3.2 DIMM
Module
Upgrade/Replacement Procedure
To replace the DIMM module:
Step 1.
Remove the controller module from the subsystem
,
and place it on a clean, static-free surface. (See
Section
5.2.2.1, Step 1-4
or
Section 5.2.2.2, Step 1-4
)
Step 2.
Remove the BBU module, if installed.
(See
Section
5.4.2, Step 1
)
Carefully place the module for it contains
Li-Ion batteries. Do not place it near any heat source.
Step 3.
Remove the previously installed DDR RAM DIMM
module.
To remove the previously installed module,
push outward on the ejector tabs, the module will pop-up
from the socket. (See the figures below)
Figure 5-8: Removing a DIMM Module on S12F-R1432
5-8
