EonStor S12F-R1432/G1433 Installation and Hardware Reference Manual
Step 2.
Assemble both the right-side and left-side front brackets
with the rear brackets. When fitting the brackets, be sure
to align the bracket joints on the front brackets with the
pre-drilled holes on the rear brackets. (See
the figure
below)
Figure 2-9: Fitting Enclosure Support Brackets
Step 3.
Determine the position where the subsystem is going to
be installed on the rack. Attach four (4) M5 cage nuts to
both of the front rack posts and two (2) to both of the rear
rack posts. The two cage nuts on the rear rack posts
should be aligned with the middle two cage nuts on the
front rack posts. (cage See the figure below)
Figure 2-10: Attaching Cage Nuts
Step 4.
Align the screw holes on the support brackets with the
cage nuts on the rack posts. Place the bracket into the
rack and slide the brackets to adjust them to the length
between rack posts as shown below.
2-12
