EonStor S12F-R1432/G1433 Installation and Hardware Reference Manual
Figure 5-22: Removing the Cooling Module on S12F-R1432
Step 3.
Remove the retention screw on the side of PSU canister
and push the release tab forward to disengage the
cooling module.
Step 4.
Remove the cooling fan module by the following
steps:
Step 4-1. Use your thumb and middle finger to seize the cooling
fan module, your thumb by the upper edge of the fan
guard and your middle finger at the hemispheric indent.
Step 4-2. Use one hand to push the release tab forward and
another to remove the fan assembly with a precisely
vertical motion.
Step 5.
Install the replacement module
by aligning it with the
module bay on the PSU module and gently lowering it
into the bay with a precisely vertical motion. The side with
screw holes should be facing up.
Step 6.
Once the fan is fully inserted, push the release tab
backward to its original position so that the cooling
module’s connector can correctly mate with the connector
in the module bay. Fasten the retention screw next to the
release tab.
5-18
