Chapter 2: Hardware Installation
Step 2.
Adjust the drive’s location
until the mounting holes in
the drive canister are aligned with those on the hard
drive.
Step 3.
Secure the drive
with four (4) of the supplied 6/32 flat-
head screws. Please use the first and the fourth screw
hole counted from the open side. (See the figure below)
Figure 2-17: Screw Holes for Hard Drive Installation without MUX
2.7.3
Drive Installation with MUX Kit
Step 1.
Place the hard drive into the drive tray
, making sure
that the connector at the back of the drive is facing the
open side of the drive tray and the label side is facing up.
Step 2.
Connect the drive to the MUX kit
by sliding it towards
the open side of the drive tray until a solid connection
between the drive connector and the MUX kit connector
has been made. (See the figure below)
Figure 2-18: Installing a Hard Drive with a MUX Kit
Step 3.
Insert four (4) supplied 6/32 flat-head retention screws to
secure the hard drive. Please use the third and the sixth
screw holes counted from the open side. (See
the figure
above)
2-17
