Inficon ULTRATEST UL3000 Fab, Translation Of The Original Operating Instructions

Page: 59 / 140

INFICON Operation | 6
UL3000-Fab-Operating-instructions-iina73en1-08-(1910) 59 / 140
ð
Enter a value of your choice in hours for the "Air filter" or press the adjacent
"Default value" button (2500 hours).
3 Save .
After performing a maintenance, you should reset the desired period until the next
maintenance.
See also
2 Change the filter mat inside the tool box [ } 101]
2 Replacement of the filter mat on the bottom of the device [ } 102]
2 Replacing the SL200 sniffer line filter [ } 104]
2 Replacing the SL3000 sniffer line filter [ } 105]
6.2.12 Activate or deactivate maintenance requests
Enables or disables warnings when the time for maintenance is exceeded. The time
until the next maintenance is displayed.
ü
Supervisor - rights
1 > Setup > Maintenance requests
ð
In the “Enable/disable maintenance requests” window, you can activate or
deactivate the maintenance requests for the following modules:
- Calibration leak
- TMP
- Filter sniffer tip
- backing pump
- Exhaust filter
- Air filter
2
Set up.
3
Save .
6.2.13 Activating or deactivating calibration requests
If the option "calibration request” is not active (factory setting), you only get a
calibration request in the following cases:
• The operation mode “Auto Leak Test“ has been switched on and the testing time
of Auto Leak Test has been changed.
• A SL3000 sniffer line with a new serial number has been connected (UL3000 Fab
PLUS only).
• The operation mode has been changed via the operating unit and there was no
calibration in the new operation mode within the last 24 hours.