Inficon ULTRATEST UL3000 Fab, Translation Of The Original Operating Instructions

Page: 88 / 140

7 | Warning and error messages INFICON
88 / 140 UL3000-Fab-Operating-instructions-iina73en1-08-(1910)
Type Notification Possible sources of
error
Remedy
W104 One EEPROM parameter
has been initialized
A new parameter was
introduced by a
software update
• Confirm the warning message
• Check that the message does not appear
when you restart the device
• Check whether the factory settings
correspond with the new parameter of
your application
The EEPROM on the
VI-Board is defective
• Confirm the warning message
• Check if the message occurs each time
when you restart the device
• Contact customer service
W106 Several EEPROM
parameters have been
initialized
A software update
introduced new
parameters
• Confirm the warning message
• Check that the message does not appear
when you restart the device
• Check whether the factory settings
comply with the new parameters of your
application
The EEPROM on the
VI-Board was replaced
• Confirm the warning message
• Check that the message does not appear
when you restart the device
• Check whether the factory settings
comply with the new parameters of your
application
The EEPROM on the
VI-Board is defective
• Confirm the warning message
• Check if the message occurs each time
when you restart the device
• Contact customer service
E107 Internal IIC communication
error
Internal IIC
communication error
• Contact customer service
E108 Internal IIC2 communication
error
Internal IIC2
communication error
• Contact customer service