Inficon ULTRATEST UL3000 Fab, Translation Of The Original Operating Instructions

Page: 107 / 140

INFICON Cleaning and maintenance | 8
UL3000-Fab-Operating-instructions-iina73en1-08-(1910) 107 / 140
8
If you have activated the display of maintenance requests, set the maintenance
interval to the desired new period. Also see "Activate or deactivate maintenance
requests [
}
59] " and "Set maintenance interval "Filter sniffer tip" or "Air
filter" [
}
58]".
Replacing the sinter
filter of the sniffer
handle
The sinter filter is in the sniffer handle. To replace the filter inserts, proceed as follows:
1
Switch off the leak detector.
2
Unscrew the two cross-head screws that hold the sniffer probe in place.
3
Remove sinter filter including o-ring.
Fig. 18: Sinter filter in the sniffer handle
4 Check the filter for visible soiling.
5 Insert a new sinter filter with o-ring in the base of the filter tip.
6 Tighten the sniffer tip again.
7 Switch on the leak detector.
8 Close the sniffer probe with your finger. You should be able to feel the
underpressure. If not then there is a leak somewhere and you have to check
sniffer probe and handle.
9 If necessary, set the maintenance interval to the desired new period. See also
"Set maintenance interval "Filter sniffer tip" or "Air filter" [
}
58]".
8.6 Creating screenshots
You can save the current screen contents of the device to an image file. You can use
such a file for service communication, for example.
1
Create a directory named "Screenshots" on a USB stick (FAT 32 formatted).
2
To take a screenshot, connect the USB stick to one of the USB ports of the leak
detector, see also the back of the “Control unit [ } 21]“.
ð A screenshot is automatically taken and stored in the directory on the USB
stick. The date and time are also saved.
3
To take another screenshot, disconnect the USB stick from the USB port and
then reconnect it to the leak detector.