Working with the hardware in the minitower system unit
117
Installing a drive in bay 5
Bay 5 can hold a 3.5-inch slim hard disk.
1.
To attach the mounting bracket, align the screw
holes and insert the two screws.
note:
The drive is drawn in this position to show
bracket attachment. Once the bracket is installed
on the drive, rotate the drive 180 degrees so that
the front of the drive faces the front of the system
unit.
Hard Disk
(Front View)
Mounting
Bracket
Drive
Connectors
2.
Insert the hard disk (with the bracket attached) into
the bay. Align the screw holes and insert the four
screws. Connect the power and signal cables. (To
ensure that your hard drive functions properly,
read “Guidelines for connecting IDE/ATA signal
cables” on page 111 before connecting the cables.)
Drive
Signal Cable
Power Cable
(Back View)
Summary of Contents for Aptiva
