Huber Pilot ONE Unistat T3*0, Operation Manual

Page: 95 / 100

Shutting down
Chapter 8 OPERATION MANUAL
V2.4.0en/22.07.20//17.12
Unistat® T300 Series
95
8 Shutting down
8.1 Safety instructions and basic principles
Connection/adjustment to the power supply not carried out by an electrician and/or connection
to a power socket without protective earth (PE)
MORTAL DANGER FROM ELECTRIC SHOCK

Have the connection/adjustment to the power supply carried out by an electrician.

Always connect the temperature control unit to safety sockets (PE).
Damaged power cable/power cable connection
MORTAL DANGER FROM ELECTRIC SHOCK

Do not start up the temperature control unit.

Isolate the temperature control unit from the power supply.

Have the power supply cable/power supply connection replaced and inspected by an electri-
cian.
Risk of tipping due to unstable temperature control unit
SERIOUS INJURY AND PROPERTY DAMAGE

Avoid risk of tipping due to unstable temperature control unit.
Non-compliance with the safety data sheet for the thermal fluid to be used
INJURIES

Risk of injury to the eyes, skin, respiratory tract.

The safety data sheet for the thermal fluid to be used must be read prior to using it and its
content must be respected.

Observe the local regulations/work instructions.

Wear your personal protective equipment (e.g. temperature-resistant safety gloves, safety
goggles, safety footwear).

Danger of slipping because floor and work area are contaminated. Clean the work station and
follow the instructions for the disposal of thermal fluid and material on page 17 in section
»Proper disposal of resources and consumables« .
Hot or very cold thermal fluid
SEVERE BURNS/FROSTBITE OF LIMBS

Before draining, ensure that the thermal fluid has room temperature (20 °C).

If, at this temperature, the thermal fluid is too viscous to be drained: Control the temperature
of the thermal fluid for a few minutes until the viscosity will allow drainage. Never control the
temperature of the thermal fluid when the Drain is open.

Danger of burns when draining thermal fluids at temperatures above 20 °C.

Wear your Personal Protective Equipment for draining.

Only drain using suitable drainage hose and collecting container. These must be compatible
with the thermal fluid and its temperature.
All safety instructions are important and must be followed accordingly during working operations!
8.2 Switch-off
PROCEDURE

Turn off the temperature control unit.

Disconnect the temperature control unit from the power supply connection.