Huber Pilot ONE Unistat T3*0, Operation Manual

Page: 60 / 100

Setup mode
OPERATION MANUAL Chapter 4
Unistat® T300 Series
V2.4.0en/22.07.20//17.12
60
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Control Dynamics”.

Choose between the dialog entries “Fast, small overshoot” and “Without overshoot”.

Confirm your choice by tapping on “OK”.
4.2.8.3 Sub-category: “Fluid Properties”
4.2.8.3.1 Sub-category “Select Fluid”
Under this entry, you can select the thermal fluid used from a list.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Fluid Properties”.

Tap on the sub-category “Select Fluid”.

Select the thermal fluid used from the list.

Confirm your choice by tapping on “OK”.
Internal, aperiodic
temperature control
Internal, dynamic
temperature control
with possible over-
shooting of the tem-
perature