Huber Pilot ONE Unistat T3*0, Operation Manual

Page: 26 / 100

Commissioning
OPERATION MANUAL Chapter 2
Unistat® T300 Series
V2.4.0en/22.07.20//17.12
26
2.2.3 Transportation lock Type C
Remove the side panel on the temperature control unit to loosen and tighten the transportation
locks.
2.2.3.1 Releasing transportation lock Type C
Loosen the
>Hexagonal head bolt<
[A] from the
>Nut<
[C]. Remove the
>Hexagonal head bolt<
[A],
>Washer<
[B],
>Transportation lock<
[D] and
>Nut<
[C] from the temperature control unit. Keep all
individual parts for later use.
2.2.3.2 Tightening transportation lock Type C
Mount the >Hexagonal head bolt< [A], >Washer< [B], >Transportation lock< [D], >Washer< [B] and
>Nut< [C] inside the temperature control unit.
2.3 Unpacking
Starting up a damaged temperature control unit
MORTAL DANGER FROM ELECTRIC SHOCK

Do not operate a damaged temperature control unit.

Please contact the Customer Support. The telephone number can be found on page 98, section
»Contact data« .
PROCEDURE

Check for damage to the packaging. Damage can indicate property damage to the temperature
control unit.

Check for any transport damage when unpacking the temperature control unit.

Always contact your forwarding agent regarding the settlement of claims.

Follow the instructions for the disposal of packaging material on page 17 section »Proper dis-
posal of resources and consumables« .
2.4 Ambient conditions
Unsuitable ambient conditions/unsuitable installation
SERIOUS INJURY DUE TO CRUSHING

Comply with the requirements under sections »Ambient conditions« and »Installation condi-
tions« .
Make sure there is adequate fresh air available at the site for the circulation pump and the com-
pressors. The warm exhaust air must be able to escape upwards unhindered.
Free-standing model
For the connection data, see the data sheet (from page 99 in Section »Annex« ).
Example:
Transportation lock
Type C