Huber Pilot ONE Unistat T3*0, Operation Manual

Page: 83 / 100

Interfaces and software update
Chapter 6 OPERATION MANUAL
V2.4.0en/22.07.20//17.12
Unistat® T300 Series
83
6.3.1 Jack LEVEL (Com.G@te® external only)
For level monitoring in the >Sight glass< [23].
This connection enables you to connect an external float switch (Order No. 6152), which is posi-
tioned in the >Sight glass< [23], for monitoring the level of your externally closed application. Acti-
vation via a potential-free contact.
The interface is specified as a digital input. Do not apply voltage or current.
Pin Description
1 Level test (bypass via contact 2 → “absence”)
2 Level – (GND)
3 Level + (normally open contact)
6.3.2 Connector POKO (floating contact) alarm
Information on the interface can be found on page 79 in Section »Connector POKO (floating con-
tact) alarm« .
6.3.3 Jack AIF Reg-E-Prog
The analog interface has a programmable input channel and 3 output channels.
The analog interface of Com.G@te® is programmed in the category “Interfaces”.
Pin Description Signal
1 Current output, T external 0
a)
/4 - 20 mA or 0 - 10 V
If using 0 - 10 V, integrate a
500 Ω resistor.
2 Current output, setpoint 0 a) /4 - 20 mA or 0 - 10 V
3 GND for analog outputs GND
4 Analog input (programmable) 0 a) /4 - 20 mA or 0 - 10 V
Power input: 200 Ω working
resistance
Voltage input: 100 kΩ input
resistance
5 Current output, freely programmable 0 a) /4 - 20 mA or 0 - 10 V
If using 0 - 10 V, integrate a
500 Ω resistor.
6 GND for analog input GND
a) Consult with our Customer Support.
Pin assignment (front
view)
Pin assignment
Pin assignment (front
view)
Pin assignment