Huber Pilot ONE Unistat T3*0, Operation Manual

Page: 55 / 100

Setup mode
Chapter 4 OPERATION MANUAL
V2.4.0en/22.07.20//17.12
Unistat® T300 Series
55
the temperature control unit in a Profibus environment. For more information, see the pages from
77, section
»Interfaces and software update«
.
The capacity adjustment of the temperature control unit is optimized so that the specified pro-
cesses are run through in the fastest possible time. This increases the productivity of the system as
a whole and thus saves energy in the long term.
4.2.1 Select temperature control: Internal or process
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “Process/Internal”.

Choose between the entries “Internal” and “Process (Cascade)”.

Confirm your choice by tapping on “OK”.
4.2.2 Temperature control to internal temperature
With internal temperature control, a control circuit is used to control the temperature at the inter-
nal Pt100 temperature sensor. This Pt100 temperature sensor is built into the device and is located
close to thermal fluid outlet (forward flow) or in the bath tank.
Diagram of tempera-
ture control circuit
Representation of an
optimum internal
temperature control