Huber Pilot ONE Unistat T3*0, Operation Manual

Page: 82 / 100

Interfaces and software update
OPERATION MANUAL Chapter 6
Unistat® T300 Series
V2.4.0en/22.07.20//17.12
82
Pin Signal
1 I+
2 U+
3 U−
4 I−
6.3 Interfaces at the Com.G@te® (optional)
Connecting to the interfaces at the temperature control unit during operation
DAMAGE TO THE INTERFACES

When devices in operation are connected with interfaces of the temperature control unit,
interfaces may get damaged.

Before connecting, ensure the temperature control unit and the device to be connected are
turned off.
If the >Com.G@te< [46] is not connected, proceed as follows.
PROCEDURE

Switch off the temperature control unit.

Plug the >Com.G@te< [46] into the slot provided.

Switch on the temperature control unit. “Unistat Control ONE” detects the new component. The
>Com.G@te< [46] is operable.
Note that you may only change
>Com.G@te< [46] when the temperature control unit is turned off.
In the category “Interfaces” you can change the settings of each function such as PoKo, analog
interface and RS232/RS485.
You may order >Com.G@te< [46] with Order No. 6915. You can extend an existing >Com.G@te<
[46] via a connecting cable (Order No. 16160).
Pin assignment
Com.G@te external
interfaces:
LEVEL, POKO, AIF,
ECS,RS232/RS485
(left to right).
Com.G@te internal
interfaces:
POKO, AIF, ECS,
RS232/RS485
(left to right).