TRACE EXCEPTION:
This can only be caused by an internal
processor error. Refer to Chapter 4 for instructions on contacting a
qualified service technician.
TRAP0 EXCEPTION:
This can only be caused by an internal
processor error. Refer to Chapter 4 for instructions on contacting a
qualified service technician.
TRAP3 EXCEPTION:
This can only be caused by an internal
processor error. Refer to Chapter 4 for instructions on contacting a
qualified service technician.
Too many test patches !!:
This error will only occur if the service
adjustment menu is accessed. Specifically, the maximum number of
test patches has been reached and can accept no more.
WAIT-SAVING CALIBRATION:
This error will only occur if the
service adjustment menu is accessed. Specifically, a save calibration
has been initiated and not yet completed when another request is
made.
WRONG PASSWORD:
This error occurs when the service
adjustment menu password is entered incorrectly or the wrong
password has been used. Qualified service technicians, refer
to “ADJUSTMENTS,” in the
HP 8360 B-Series Swept Signal
Generator/HP 8360 L-Series Swept CW Generator Service Guide
for
more information.
Swept CW Generator
0, No Error:
This message indicates that the device has no errors
Specific
Error
and is currently ready to perform the operations for which it is
Messages
designed.
1, FUNCTION DISABLED:
The particular function invoked has
been disabled by a calibration constant. If you need access to the
function, contact a qualified service technician.
2, Wrong password:
This error occurs when the service adjustment
menu password is entered incorrectly or the wrong password has been
used. Qualified service technicians, refer to “ADJUSTMENTS,” in
the
HP 8360 B-Series Swept Signal Generator/HP 8360 L-Series
Swept CW Generator Service Guide
for more information.
4, Unable to store data in EEROM
5, Not allowed to change address
6, Switch on Processor Board is Set:
This error occurs when
a service adjustment menu password can not be set because the
Error Messages
