Use of the Command Tables
In Table 1-4, notice that a new column titled “Allowed Values” has
been added to the command table. This column lists the specific
values or range of values allowed for each parameter. A vertical bar
separates values in a list from which you must choose one value.
The commands listed in the table are only part of all the available
SCPI commands of the swept CW generator. For a complete listing
of the programming codes see “SCPI Command Summary” in
Chapter 2.
Table 1-4. Sample Swept CW Generator Commands
Command
Parameters
Parameter Type
Allowed Values
flatness array
to cal
discrete
measured power
extended numeric
[lvl suffix]
801
correction pairs
extended numeric
[freq suffix],
center freq
CW freq
extended numeric
extended numeric
specified freq
range
or
specified freq range
or
coupled to
center freq
Boolean
free mode
start freq
discrete
extended numeric
specified freq range
or
auto freq step
freq step
Boolean
extended numeric
20 to 0.01
or
stop freq
extended numeric
specified freq range
or
[n] is 1 to 5, 1 is the
default
marker frequency
extended numeric
specified freq range
or
1-88 Getting Started Programming