Hioki LR8450, Instruction Manual

Page: 41 / 310

37
Configuring the Waveform Display
Unit Measure Channel Trigger Alarm Calculation System
3
Under [Zero position] , set where to place the waveform’s zero point (0 V, 0°C, etc.).
−50%
to
150%
(×1  )
150%
100%
50%
0%
−50%
Top edge of screen: 100%
Bottom edge of screen: 0%
Center of screen: 50%
Screen
You can set off-screen values.
With a vertical axis zoom factor of 1×: Up to 150%
You can set off-screen values.
With a vertical axis zoom factor of 1×: Down to −50%
Screen
The range of available zero position settings will depend on the zoom factor.
4
(When using scaling, or when [Number display format] is set to a value other than [Standard] )
Under [Num of decimal places] , set the number of decimal places to use for measured
values.
0 , 1 , 2 , 3

, 4 , 5 , 6 , 7 , 8 , 9 , 10
When using scaling, a large number of decimal places, for example 5, may be used. If you wish
to reduce the number of decimal places, set
[Num of decimal places]
to a small value.
Example: 1.23456 mV → 1.23 mV (when [Num of decimal places] is set to [2] )
1
Settings and Operation