305
Examples
# Create dialer group 1 and configure DDR to place calls for IPv4 packets. Associate Serial 2/1/0
with dialer group 1.
<Sysname> system-view
[Sysname] dialer-group 1 rule ip permit
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer-group 1
# Create dialer group 1 and configure DDR to place calls for IPv6 packets. Associate Serial 2/1/0
with dialer group 1.
<Sysname> system-view
[Sysname] dialer-group 1 rule ipv6 permit
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer-group 1
Related commands
dialer-group
display dialer
Use
display dialer
to display the DDR information for an interface.
Syntax
display dialer
[
interface
interface-type interface-number
]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface
interface-type interface-number
:
Specifies an interface by its type and number. If you do
not specify an interface, this command displays the DDR information for all interfaces.
Examples
# Display the DDR information for all interfaces.
<Sysname> display dialer
Dialer0:
Dialer Route:
NextHop: 111.111.111.111 Dialer number: 123456789012345678901234567890
NextHop: 222.222.222.222 Dialer number: 123456789012345678901234567890
Dialer number:
Dialer Timers(in seconds):
Auto-dial: 300 Compete: 20 Enable: 5
Idle: 120 Wait-for-Carrier: 60
Total Channels: 1
Free Channels: 1
Summary of Contents for MSR810
Page 148: ...136 Related commands timer hold...
Page 331: ...319 Related commands timer hold...
