53
Examples
# Set the maximum LFI fragment size to 80 bytes on MP-group 2/0/0.
<Sysname> system-view
[Sysname] interface mp-group 2/0/0
[Sysname-MP-group2/0/0] ppp mp lfi size-per-frag 80
Related commands
ppp mp lfi enable
ppp mp lfi delay-per-frag
ppp mp max-bind
Use
ppp mp max-bind
to set the maximum number of PPP links in an MP bundle on an interface.
Use
undo ppp mp max-bind
to restore the default.
Syntax
ppp mp
max-bind
max-bind-num
undo ppp mp max-bind
Default
The maximum number of PPP links in an MP bundle is 16 on an interface.
Views
VT interface view
Dialer interface view
MP-group interface view
Predefined user roles
network-admin
Parameters
max-bind-num
: Specifies the maximum number of PPP links in an MP bundle, in the range of 1 to
128.
Usage guidelines
IMPORTANT:
Use the default setting in most situations. Inappropriate use of this command can cause PPP
performance degradation. Make sure you understand the impact of this command on your network
before you use it.
Set the maximum number of PPP links in an MP bundle to be greater than the actual number of
bound links. Otherwise, MP binding fails.
The maximum number of PPP links configured for an MP bundle takes effect immediately. If the
configured maximum number is smaller than the number of existing PPP links, the existing links are
not affected.
Examples
# Set the maximum number of PPP links in an MP bundle to 12 on MP-group 2/0/0.
<Sysname> system-view
[Sysname] interface mp-group 2/0/0
[Sysname-MP-group2/0/0] ppp mp max-bind 12
Summary of Contents for MSR810
Page 148: ...136 Related commands timer hold...
Page 331: ...319 Related commands timer hold...
