H3C MSR810, Command Reference Manual

Page: 88 / 389

76
Parameters
cn-telecom
: Specifies China Telecom format.
tr-101
: Specifies TR-101 format.
Usage guidelines
The circuit-id formats include TR-101 and China Telecom.
The TR-101 format is Access-Node-Identifier atm slot/port:vpi.vci for ATM/DSL, and i s
Access-Node-Identifier eth slot/port[:vlan-id] for Ethernet/DSL. The entire ID refers to the user
access information on the DSLAM, where
• Access-Node-Identifier refers to the identifier of the DSLAM.
• The remainder refers to information about the user access interface on the DSLAM.
The China-Telecom format is {atm|eth|trunk} NAS_slot/NAS_subslot/NAS_port:XPI.XCI
AccessNodeIdentifier/ANI_rack/ANI_frame/ANI_slot/ANI_subslot/ANI_port[:ANI_XPI.ANI_XCI],
where:
• {atm|eth|trunk} NAS_slot/NAS_subslot/NAS_port:XPI.XCI refers to DSLAM upstream interface
information, including upstream interface, VLAN, and VPI/VCI information:

When ATM/DSL is used, XPI.XCI refers to VPI/VCI information.

When Ethernet/DSL is used, XPI.XCI refers to VLAN information.
• The remainder refers to user access information on the DSLAM, including DSLAM identifier and
user access interface.
For example, the circuit-id ge 1/0/1:4096.2345 guangzhou001/1/31/63/31/127 includes the following
information:
• DSLAM upstream interface information:

The type of the upstream interface is Ethernet interface.

The interface is located at slot 1, subslot 0, and port 1.

The outer VLAN ID is 4096 that means invalid VLAN, and the inner VLAN ID is 2345.
• User access information on the DSLAM:

The identifier of the access node DSLAM is guangzhou001.

The rack number of the DSLAM is 1.

The user access interface is located at port 127, subslot 3, slot 63, and frame 31.
Examples
# Configure GigabitEthernet 1/0/1 to use China Telecom format to parse the circuit-id.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-server access-line-id circuit-id parse-mode
cn-telecom
Related commands
pppoe-server access-line-id circuit-id trans-format
pppoe-server access-line-id circuit-id trans-format
Use
pppoe-server access-line-id circuit-id trans-format
to configure the transmission format for
the circuit-id in access line ID on an interface.
Use
undo pppoe-server access-line-id circuit-id trans-format
to restore the default.
Syntax
pppoe-server access-line-id circuit-id trans-format
{
ascii
|
hex
}