125
Default
The source IP address of L2TP tunnel packets is the IP address of the egress interface.
Views
L2TP group view
Predefined user roles
network-admin
Parameters
ip-address
: Specifies the source IP address of L2TP tunnel packets.
Usage guidelines
This command is available only on an L2TP group in LAC mode.
As a best practice to ensure high availability, use the IP address of a loopback interface as the
source IP address of L2TP tunnel packets.
Examples
# Configure the source IP address of L2TP tunnel packets as
2.2.2.2
.
<Sysname> system-view
[Sysname] l2tp-group 1 mode lac
[Sysname-l2tp1] source-ip 2.2.2.2
timer-hold
Use
timer-hold
to set the keepalive interval.
Use
undo timer-hold
to restore the default.
Syntax
timer-hold
seconds
undo timer-hold
Default
The keepalive interval is 10 seconds.
Views
Virtual PPP interface view
Predefined user roles
network-admin
Parameters
seconds
: Specifies the interval at which the LAC or the LNS sends keepalive packets, in the range of
0 to 32767 seconds.
Usage guidelines
A virtual PPP interface sends keepalive packets at keepalive intervals to detect the availability of the
peer. If the interface fails to receive keepalive packets when the keepalive retry limit is reached, it
considers the link faulty and reports a link layer down event.
To set the keepalive retry limit, use the
timer-hold retry
command.
On a s low link, increase the keepalive interval to prevent false shutdown of the interface. This
situation might occur when keepalive packets are delayed because a l arge packet is being
transmitted on the link.
Summary of Contents for MSR810
Page 148: ...136 Related commands timer hold...
Page 331: ...319 Related commands timer hold...
