H3C MSR810, Command Reference Manual

Page: 92 / 389

80
Usage guidelines
This command enables the PPPoE server to parse the circuit-id and remote-id in a received packet,
and creates a new circuit-id and r emote-id. If the PPPoE server fails to parse the circuit-id or
remote-id in a PADR packet, it discards the packet and does not return a PADS packet.
If this command is not executed, the PPPoE server does not parse the circuit-id and remote-id in a
received packet. The contents of both the new circuit-id and the remote-id are null.
Examples
# Configure GigabitEthernet 1/0/1 to trust the access line ID in received packets.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-server access-line-id trust
Related commands
pppoe-server access-line-id circuit-id parse-mode
pppoe-server bind
Use
pppoe-server bind
to enable the PPPoE server on an interface and bind the interface to a VT
interface.
Use
undo pppoe-server bind
to disable the PPPoE server on an interface.
Syntax
pppoe-server bind virtual-template number
undo pppoe-server bind
Default
The PPPoE server is disabled on an interface.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Layer 3 aggregate interface/subinterface view
VE-L3VPN interface/subinterface view
EFM interface/subinterface view
Predefined user roles
network-admin
Parameters
virtual template number
: Specifies a VT interface by its number.
The following matrix shows the value ranges for the
number
argument:
Hardware Value range
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-H
K/810-LMS/810-LUS
0 to 1023
MSR2600-10-X1 0 to 1023
MSR 2630 0 to 1023