GSK GSK983Ma, User Manual

Page: 70 / 373

GSK983Ma Milling Machine Center CNC System User Manual
58
Part 1 Programming
The boundary is set by the parameter, and the specified boundary is called forbidden area.
Usually, it is never changed after the manufactory is set. So, it is set at the maximum stroke of
machine which is equivalent the soft limit.
Stored stroke limit 2:
The boundary is specified by the parameter or command, the specified area (inside or outside) is
forbidden area, which is determined by BIT6 of parameter 009 (RWL).
G22 code can be stop the tool enters the forbidden area, and the G23 code can be lift the
forbidden area.
Creating or changing the forbidden area using a command
G22 X___Y___Z___I___J___K___
；
X
＞
I
，
Y
＞
J
，
Z
＞
K
X
－
I
＞
2000 (The least command increment)
Y － J ＞ 2000 (The least command increment)
Z
－
K
＞
2000 (The least command increment)
When setting the area by parameters, points A and B in the figure below must be set.
X
1
＞ X
2
， Y
1
＞ Y
2
， Z
1
＞ Z
2
X
1
－
X
2
＞
2000 (The least command increment)
Y
1
－
Y
2
＞
2000 (The least command increment)
Z
1
－ Z
2
＞ 2000 (The least command increment)
If the forbidden area is set by parameter, the X Y Z I J K should be set by the least move unit
(output unit) of the mechanical coordinate system which is regarded as zero point by the reference
position.
If it is set by G22 code, the X Y Z I J K should be programmed by the least input increment (input
unit) of the mechanical coordinate system which is regarded as zero point by the reference position.
The programmed data is then became the numerical digit value of the least movement unit, which this
value is treated as parameter setting.