GSK GSK983Ma, User Manual

Page: 291 / 373

Chapter Four Operation
279
Part 2
Operation
Z
Starting point of the program
（
70
，
120
）
30
X
40
90
A. Drawing for the whole tool path
If the maximum and minimum values are set as follows
Value
（ MAX ） ， Value （ MIN ）
X= 70000
，
0
Y= 0 ， 0
Z= 120000
，
0
The graphic center is
（
35000
，
60000
）
The scaling is set automatically
B. Drawing for the shadow part
Value
（
MAX
） ，
Value
（
MIN
）
X= 30000 ， 0
Y= 0
，
0
Z= 90000
，
40000
The graphic center is （ 15000 ， 65000 ）
The scaling is set automatically
C. To move the drafting position, change the values of MAX. and MIN. with the same value.
MAX+
α
，
MIN+ α
α <0
，
Upward or deviate to the right side
α >0
，
Downward or deviate to the left side
In three dimension: α <0, graphic deviates to the positive direction of the axis
α >0, graphic deviates to the negative direction of the axis
Note 1: Maximum is bigger than minimum.
Note 2: After the maximum and minimum are set, the center of the corresponding figure is set
automatically. The scale is set automatically in two dimension coordinate, but it is set
manually in three dimension coordinate.
4.5.3.5 Scaling
Set the graphic scaling (The value is valid when the maximum and minimum are not set. If the
maximum and minimum are set, the value will be changed automatically)
Setting range: 1~10000 Setting unit: 0.01 fold