GSK GSK983Ma, User Manual

Page: 259 / 373

Chapter Four Operation
247
Part 2
Operation
AUTO mode and runit. At this time, the block locating at the cursor in Edit mode is
read into the buffer register.
（
3
）
Modes other than Edit and AUTO mode
Press PROGRAM key to display the screen contains the block being executed and the following
blocks to be executed.
4.4.16 Program Number Retrieving (functional key PROGRAM)
When several programs are stored in storage, each of them can be retrieved.
0 1001 0 3054 0 1972
Retrieve program number
（
1
）
Method 1
（
a
）
Selection mode (EDIT or AUTO mode)
（ b ） Press PROGRAM key.
（
c
）
Input O and program number. to be retrieved and then press ↓ .The page of
the program is displayed after retrieving.
（ 2 ） Method 2
（ a ） Select AUTO mode.
（
b
）
Press PROGRAM key.
（
c
）
Press O
，
Cancel and cursor key ↓ in succession.
（
3
）
Method 3
（ a ） Select Edit mode
（ b ） Press PROGRAM key.
（ c ） Press O ↓ to display the next stored program. Press the cursor continuously,
and saved programs are displayed in succession, which is used to check the saved
program number..
Note 1: It returns to the beginning when the stored program numbers are displayed
once.
Note 2: The contents in the buffer register are cancelled when program number
search starts..
4.4.17 Input a Single Program File
（
a
）
Each of the functional key can be pressed when program lock is ON.
（
b
）
Select EDIT or AUTO mode.
（ c ） Connect communication cable to make the input device (PC or USB switch box) in a
preparation state.
（
d
）
When input program without program No. or it needs modification, key in program Number:
Key in O Program Number. (When input program contains program Number or it dosen’t need
modification, this operation is not required)
（ e ） Press Data Input key, programs are being transmitted, and EDIT is blinking and displayed at
the lower part of the screen.
（
f
）
Press PROGRAM key, the contents display from the begining of input program.