GSK GSK983Ma, User Manual

Page: 257 / 373

Chapter Four Operation
245
Part 2
Operation
（
3
）
Move the cursor to the Number to be altered
Press cursor key ↑ or ↓ key to move the cursor in sequence. It will change to the next page if the
cursor is over a page.
（ 4 ） Mode selection can be set to any position.
Method 1: Key in X
、
Y
、
Z or 4TH/5TH and workpiece coordinate system offset to be
altered or to be set, and then press INPUT key.
Method 2: Key in X 0
，
Y 0
，
Z 0
或
4TH/5TH 0
，
and then press “MEASUR”
key, it will automatically set current machine coordinates to the workpiece orgin offset of
workpiece coordinate system that to be changed.
Note: The offset setting scope of workpiece coordinate is the same as the value range of
coordinates.
4.4.14 The method of Measuring Tool Length
（ 1 ） Press OFFSET key to select the page of offset value.
（ 2 ） Select standard tool, and manually make it contact with the fixed point (or workpiece
reference point) of the machine tool.
（
3
）
Press Z and SHIFT key to clear the corresponding coordinates of Z axis.
（
4
）
Then select the tool to be measured, and manually make it contact with the same fixed point.
At this moment, the difference between standard tool and the tool to be measured is
displayed on relative position display.
（
5
）
The same as offset setting, move the cursor to offset Number, and press Z and INPUT
key, but don’t key in numeric value, the measured difference value is input as offset value.
4.4.15 Program Display (Functional key PROGRAM)
（ 1 ） In Edit mode, press PROGRAM key, the page containing the currently selected program is
displayed.