EP OS MOTOR MANAGEMENT SY STEM – INSTRUCTION MANUAL
CHAPTER 5: WinESG
5.2
5
5.3.2.9 I/O’s panel
The I/O panel provides a mean for mapping the inputs and outputs. Refer to figure 5-15 for the WinESG
parameterization I/O panel. The mapping can be changed by unselecting the default configuration in the
parameterization/Information panel.
Figure 5-15: WinESG parameterization
I/O
panel
CAUTION:
Do not assign outputs as flas
hing
Drawer is ready state, General warning, General fault, Safety circuit, Switch set to local, Switch set to remote, Drawer in operation
hingMain contactor 1, Main contactor 2, ATEX redundancy contactor, Parameter allowed, Switch protected, Start attempt exceeded,
Motor in run phase.
Thermistor shorted, Main contactor 1 switching in progress, Main contactor 2 switching in progress, Motor is start phase
Drawer in test mode, General device error, Device identification, profibus class 1 failure, Modbus failure, Thermistor broken,
Output relays can be mapped to following as solid on or flashing
local, Reset alarm, Main circuit feedback, Control circuit feedback, Emergency stop, safety circuit.
feedback, External fault 1, External fault 2, Drawer in operation position, Drawer in test position, Mode switch remote, Mode switch
Main contactor 1 ON command, Main contactor 2 ON command, OFF command, Main contactor 1 feedback, Main contactor 2 I
Inputs can be mapped to following as active high or active low:
Same input should NOT be mapped to active high and low at the same time.
in both low priority, and high priority.
Do not assign same input as active low and high.