4.12
EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: COMMUNICATION
93
Reset Overload Current Warning
94
Reset External Supervision Warning
95
Reset Long Start Warning
96
Reset Typical Specific Warning
99
Reset Parameter Error
100
Reset Watchdog Error
101
Reset Timer Interrupt Error
102
Reset Current Measurement Ungauged Error
103
Reset NOV RAM EEPROM
104
Reset Current Measurement Error
105
Reset Start Atte,[t
106
Reset Thermistor Error
113
RESET Operation Hours
116
RESET Maximum Current
117
RESET Trip Current
119
RESET Overload Event Counter
120
CLEAR Analog Value Log
141
2
Set Analog Value Log Manual Trigger
142
Stop Analog Value Log
144
Clear Overload Accumulator
179
3
Read Real Time Clock Registers
180
Clear Event Log
181
4
Write Real Time Clock Registers
184
Set factory default parameters
Save parameters
in memory
1: If the local-remote-off switch is set to OFF, and an OFF command is received from a remote source, it
will be ignored unless the lock switch is enabled.
2: When this command is issued, the manual trigger will occur. Input holding register 58 MUST be set to
manual for this command to have any effect .
3: Value will be available on holding registers.
4; This command writes the Real Time Clock values in holding registers 76 to 83 to the EntelliPro RTC.
Table 4-5: Operation Codes for Function Code 05
188
Allow parameterization in running mode
189
Stop parameterization in running mode
18
5