GE Centricity RA600, Service Manual

Page: 256 / 278

Troubleshooting TSG 015 Connect Frame Grabber to Monitor that has no pass-through
Page 256
Note:
Be sure to observe proper ESD safety precautions when inserting the frame grabber board.
3. Depending on which channel you will use to connect the video IN, set one of the following
jumpers.
4. Replace the 1400 side cover and restart the Centricity RA600 system.
5. Connect the video source to the CA channel you have selected and then connect the
corresponding CT channel to the monitor.
6. Follow job card SW 007 to install the Imagraph software and configure the channel. The
autosync function of the softwae will automatically detect the channel that has a valid video
signal.
Note:
For more details on jumper settings refer to the Hi Def Accura card User Manual, Chapter 2.
This manual may be down loaded from http://www.foresightimaging.com or from the ROC
website, Http://e.87.17.176, under Radworks > drivers > Frame Grabbers.
Video IN
Jumper
No.
Jumper
Setting
Video OUT
CA1 J3 B CT1
CA2 J5 B CT2
CA3 J8 B CT3
CA4 J10 B CT4