CS875-575-375-275-175 Installers Manual with CS5500 keypad
B.5.10
5.1.4.2
Keyfob User ID
A menu option that makes the keyfob report as the zone that it is learned into.
When this option is disabled, all keyfobs report their open/closing reports as
user 99.
5.1.4.3
Keyfob Low Battery Reports
A menu option that reports a keyfob low battery condition. This option is
available on the 868 Mhz RF Receiver only.
The low battery condition is reset by pressing the Arm (Lock) and Disarm
(Unlock) button at the same time. If this option is enabled, each enrolled keyfob
uses up one zone in the system. If this option is disabled, keyfobs do not use
up a zone in the system and can overlap with a used zone.
5.1.4.4
Antenna Tamper
A menu option that sends a report if the antenna on the selected RF receiver is
removed or damaged (cut).
5.1.4.5
Box Tamper
A menu option that enables the box tamper switch on the selected RF receiver.
5.1.5
Supervision
A menu entry that groups wireless supervision options.
5.1.5.1
Normal Window
A menu option that specifies the normal supervision window for RF devices.
RF devices on 433 Mhz typically report every 64 minutes. RF devices on 868
Mhz typically report every 15 minutes. Depending on the country regulations,
this timer must be set to specific values.
5.1.5.2
Short Window
A menu option that specifies the short supervision window for RF devices. RF
devices on 433 Mhz typically report every 64 minutes. RF devices on 868 Mhz
typically report every 15 minutes. Depending on the country regulations, this
timer must be set to specific values.
5.1.5.3
Fire Window
A menu option that specifies the RF supervision to be used for RF smoke/fire
detectors. The RF smoke/fire detectors send a supervision every 64 minutes,
irrespective of 433 Mhz or 868 Mhz.
5.1.6
RF Signal
A menu entry that groups entries related to measuring RF signal strengths.
5.1.6.1
RSSI Check Zone
A menu option that sets the zone number on the selected RF receiver. The RF
receiver stores the signal strength of the transmission it receives from the
sensor in this zone. To read the signal strength, open and close the zone and
then select the RSSI Value menu option.
5.1.6.2
RSSI Value
Remote Signal Strength Indication Value. This is a measure of the RF
reception and is similar to the indication on a mobile phone.
A menu entry that displays the RSSI value. The value is linked to the level of
the signal between the wireless transmitters and the RF receiver.
5.1.6.3
Last Round Count
A menu option that displays the number of rounds of RF data received during
the last transmission. This option is available only on a 433 Mhz system and is
replaced by the RSSI value on an 868 Mhz system.
5.1.7
Model
A menu option that displays the model of the selected receiver.
5.1.8
Version
A menu option that displays the current software version of the selected
receiver.
5.1.9
Default Settings
A menu option that defaults the selected receiver to factory defaults.
Location
Term
Definition
