CS875-575-375-275-175 Installers Manual with CS5500 keypad
B.13.8
13.1.1.1.3.3
Power
A menu entry that groups the power events that are reported to the selected
report control.
13.1.1.1.3.3.1
Power Trouble and Restores
A menu option that reports mains failure, mains restore, low battery and low
battery restore events to the selected phone number, report control, receiver or
email account.
13.1.1.1.3.3.2
Aux Overcurrent and Restores
A menu option that sends a report to the selected report control when too
much current is detected. A restore report is also sent when the overcurrent
condition is fixed.
13.1.1.1.3.4
Communications
A menu entry that groups together the communication events that are reported
to the selected report control.
13.1.1.1.3.4.1
Fail to Communicate
A menu option that reports a fail to communicate event to the selected report
control.
13.1.1.1.3.4.2
Test Reports
A menu option that sends a test report to the selected report control at pre-
programmed intervals. The units can be set in days or hours.
13.1.1.1.3.5.1
Program/Download
A menu option that reports programming and up/download events to the
selected report control.
13.1.1.1.3.5.2
Zone Inactivity Monitor
A menu option that sends a report to the selected report control when a zone
inactivity event occurs.
13.1.1.1.4
Report Delay
A menu option that configures the delay in seconds before the CS7002 module
reports. If any other events occur during this delay, they are sent with the first
event in one message. This can be from 0 to 255 seconds. This setting is
useful only if using SMS reporting.
13.1.1.1.5
Report When
A menu option that enables primary reporting (Report Always) or secondary
reporting (Control Dialler Problem) for the selected report control.
13.1.2
TCP/IP Reporting
A menu entry that groups TCP/IP reporting options.
13.1.2.1
Receivers
A menu entry that groups TCP/IP receiver options.
13.1.2.1.1.1
IP Address
A menu option that configures the address of the selected TCP/IP receiver.
13.1.2.1.1.2
Account Code
A menu option that specifies the unique code sent from the modem in the
control panel or dialler to the selected report control or phone number. This
code is used to identify and charge the user. Separate account codes can be
set up for each phone number and each partition. This is also known as the
account number. The letters A, B, C, D, E and F can be included in CS7002
GPRS module account codes.
13.1.2.1.1.3
Receiver Number
A menu option that configures the phone line receiver number associated with
the receiver account.
13.1.2.1.1.4
Line Number
A menu option that configures the line number associated with the receiver
account.
13.1.2.2
Report Format
A menu option that configures the communicator format used to report to TCP/
IP receivers. Consult the instructions for your central station receiver to
determine which format is compatible.
13.1.2.3
Receiver Polling
A menu option that configures the module to send polling messages to the
report receivers.
13.1.2.4
Polling Time
A menu option that configures the TCP/IP polling time. This value must match
the TCP/IP polling time set on a TCP/IP receiver. The value chosen is
determined by the level of security required and the cost of data transmission.
This can be from 1 to 255 minutes. If set to 0, the option is disabled.
Location
Term
Definition
