Fujitsu MHZ2080BJ, Product/Maintenance Manual

Page: 196 / 320

Interface
*1) Data Transfer Mode
The host sets X '03' to the Features field. By issuing this command with setting a
value to the Sector Count Field, the transfer mode can be selected. Upper 5 bits of
the Sector Count register defines the transfer type and lower 3 bits specifies the
binary mode value.
The IDD supports following values in the Sector Count Field value. If other value
than below is specified, an ABORTED COMMAND error is posted.
Note: For a serial ATA device, the setting of a data transfer mode is reflected in
WORD 63 and 88 in Identify Device information. However, the actual
data transfer rate depends on the serial ATA signaling rate in WORD 76
in Identify Device information.
Transfer mode Sector Count file
•
PIO default transfer mode 00000 000 (X '00')
00001 000 (X '08': Mode 0)
00001 001 (X '09': Mode 1)
00001 010 (X '0A': Mode 2)
00001 011 (X '0B': Mode 3)
•
PIO flow control transfer mode X
00001 100 (X '0C': Mode 4)
00010 000 (X '10': Mode 0)
00010 001 (X '11': Mode 1)
•
Single word DMA Mode X
00010 010 (X '12': Mode 2)
00100 000 (X '20': Mode 0)
00100 001 (X '21': Mode 1)
•
Multiword DMA transfer mode X
00100 010 (X '22': Mode 2)
01000 000 (X '40': Mode 0)
01000 001 (X '41': Mode 1)
01000 010 (X '42': Mode 2)
01000 011 (X '43': Mode 3)
01000 100 (X '44': Mode 4)
•
Ultra DMA transfer mode X
01000 101 (X '45': Mode 5)
5-122 C141-E280