Foma SH700i, Manual

Page: 52 / 588

50
Ca
lling
/Rec
e
ivi
n
g
Check that there are sufficient battery and signal levels.
J
Checking the signal level
Approximate signal level appears.
Making Calls
1 In stand-by, dial the phone number starting with the area code.
Always dial the area code, even when the number is in the same area.
Dial up to 80 digits. When the number exceeds 13 digits, it appears on two lines.
After 26 digits has been exceeded, the last 26 digits appear on two lines.
In the dialing screen, press
0
for 1+ seconds to enter + .
When making international calls, enter this before the phone number. When + is
entered, the phone number after + is called.
For a mobile phone or PHS
When a mistake is made while dialing
Press
c
to erase the last digit.
Press
c
for 1+ seconds to erase all the digits. (Stand-by reappears.)
If
s
is pressed and then the number is dialed, pressing
c
does not erase
the digits. Press
H
. (Stand-by reappears.)
2 Press
s
.
When name and
still picture are
saved in the
phonebook
Unlike ordinary telephones, mobile phones send call tones in short beeps before
the standard ring tone.
t
appears during a voice call.
When the number is saved in the phonebook
The other party’s name and number appear. Image also appears if set in
advance.
When the other party is busy
There is a busy signal. Press
H
to disconnect and try again later.
When short beeps sound during the call
The battery level is low. The call disconnects in approximately 20 seconds. End
the call and recharge the battery.
When a guidance message plays requesting caller ID
The other party has Caller ID Request Service set to Activate . Set caller ID and call
again. (
n
P. 47, P. 53)
3 Press
H
after call.
When Assistant View (
n
P. 406) is active during a call
Press
H
to end Assistant View. Press
H
again to end call.
When
A
appears, the handset is outside the service area or in a
place with no signal. Move to a place where the icon disappears.
The call may be interrupted even when
]
appears and the signal
is strong.
When
g
appears, the handset is in Self mode (
n
P. 149). While
in Self mode, the handset cannot make/receive calls, send/receive
i-mode mail or SMS, receive Message R/F, use i-mode functions or
use Ir exchange/remote control.
Mobile phone
090-XXXX-XXXX
Other party’s number (11 digits) 080-XXXX-XXXX
PHS 070-XXXX-XXXX
Strong Weak
] n o
A
dv22̲e.book Page 50 Monday, February 14, 2005 4:58 PM