Foma SH700i, Manual

Page: 477 / 588

475
Da
ta
Com
m
uni
c
a
tio
n
Various network settings are required to
connect the FOMA terminal to a PC to send
packet transmissions and 64K data
communications. Use the FOMA PC Setup
Software to easily make the following settings.
Easy settings
Follow instructions to create dial-up settings
for FOMA data transmissions and to
automatically configure the W-TCP setting.
W-TCP settings
This optimizes the network settings in the PC
before using
FOMA packet transmission .
Use the W-TCP settings to optimize the
transmission settings and fully utilize the
transmission performance.
Host (APN) settings
This configures the host (APN) required for
packet transmissions.
The host for FOMA packet transmissions
differs from that of 64K data communications
in that a telephone number is not used. A host
name, called an APN (Access Point Name), is
registered to the FOMA terminal for each host
in advance. The registration number (cid) of
the APN is assigned to the host telephone
number field and a connection is established.
The APN
mopera.ne.jp is registered in the
first cid, as a standard, for connection to
mopera. Configure a separate APN to connect
to another provider or a corporate LAN.
cid (Context Identifier) ........
This number corresponds to the host
(APN) for packet transmissions. This
is configured when an APN is
registered in the FOMA terminal.
J
From installing the FOMA PC
Setup Software to connecting to
the Internet
Check the operating environment of the FOMA
PC Setup Software. (
n
P. 470)
STEP 1 Install the FOMA PC Setup Software
(
n
P. 476)
If the W-TCP System Setup
Software (earlier version W-TCP
Setup Software) or FOMA Data
Transmission Setup Software
(earlier version FOMA Data
Transmission Setup Software)
supplied in the FOMA terminals
listed below is installed in the PC,
uninstall this software in advance.
(FOMA N2001, FOMA N2002,
FOMA P2401, FOMA P2002, FOMA
F2611, FOMA T2101V)
The FOMA PC Setup Software can
be used with all FOMA terminals
enabled for data transmission.
STEP 2 Setup preparations
Check the following before making
any settings.
The FOMA terminal is connected to a PC
(
n
P. 470)
The FOMA terminal is recognized on the
PC (
n
P. 473)
3 Enter <CD-ROM Driver
Name>
:¥USBDRV¥sh700iu.EX
E and click OK .
4
When
アンインストールを開始
しますか？
(Start uninstalling?)
appears, click
はい
(Yes).
Uninstallation of the communication setting file
begins.
5
When
アンインストールが完了
しました。
(Uninstallation
completed.) appears, click OK .
Uninstallation of the communication setting file
finishes.
On Windows 98
If
今すぐ再起動しますか？
(Restart now?)
appears, click
はい
(Yes), and restart your PC.
Note
After uninstalling the communication setting file
from Windows Me, depending on the PC
environment, proper communication may not be
possible when using data communication after
immediate reinstallation of the file. In such cases,
remove the FOMA USB cable once, insert it again,
and then use data communication.
Communications Settings with
the FOMA PC Setup Software
FOMA PC Setup Software
Note
Alternatively, configure packet transmissions and
64K data communications without using the FOMA
PC Setup Software. (
n
P. 485)
dv22̲e.book Page 475 Monday, February 14, 2005 4:58 PM