Foma SH700i, Manual

Page: 78 / 588

76
M
aki
ng/Rec
e
iv
ing Video
-phon
e
Cal
ls
3 Talk when the other party answers the phone.
When the other party answers, Connected video-phone After connecting,
press
u
to switch to hands-free appears. Digital transmission fees are
incurred from this point.
The other party’s image appears in the main screen and your image taken with
the camera appears in the sub screen.
To send touch-tone signals <DTMF mode>
Press dial keys to enter numbers to send.
For Chara-den, press
t81
and use the dial keys to enter numbers to
send.
To view own phone number
Press
t0
.
To send a substitute image during a video-phone call
Press
i
[Subst img]. To select Chara-den, press
i
[Subst img] for 1+
seconds. (
n
P. 81)
To use Hands-free
Press
s
. (
n
P. 77)
4 Press
H
after call.
Note
Video-phone calls cannot be made to emergency numbers (110, 119, 118) from the FOMA terminal.
The call is not connected when a video-phone call is placed to an unsupported handset. If Redial voicecall is
set to
ON , the number is automatically redial as a voice call (
n
P. 89). In such cases, voice call charges are
incurred. Note that this operation may not work if a call is placed to an ISDN synchronous 64K, PIAFS access
point or a ISDN video-phone that does not support the 3G-324M standard (
n
P. 74) (as of February 2005),
or if an invalid phone number is dialed by mistake. In addition, charges may be incurred.
When making video-phone calls to a compatible FOMA terminal, it is recommended that the 64K
transmission speed be used. 32K transmission is for connecting to devices such as PHS phones that cannot
use 64K due to network conditions. If a 64K video-phone call is made to a party in a 32K area, transmission
speed is automatically switched to 32K and redialed. Redial can be used with the operation last performed.
When sending own image from a location with little light, noise such as white lines increase. Also, direct
sunlight or light from lamps may darken or distort images. Use video-phone under suitable lighting conditions.
When a voice/video-phone call is received during a video-phone call, the number is recorded in Received
calls and
Missed calls appears in stand-by.
During video-phone call, i-mode mail and Message R/F are held at the i-mode center. After a video-phone call,
i-mode mail or Message R/F messages held at the i-mode center can be retrieved by checking for new messages.
Short messages (SMS) are received automatically during video-phone calls.
When the sending/receiving of audio or video fails, the video-phone call is not automatically restored. Make
the video-phone call again.
When a video-phone call is started, Redial voicecall is not performed.
Because video-phone calls are digital communication, they are counted as Digital transmission . (
n
P. 442)
Voice calls or i-mode operations cannot be performed during a video-phone call.
If the battery runs out of power during a video-phone call, an alert sounds, the call is disconnected in
approximately 20 seconds, and the power turns off in approximately 60 seconds.
Digital transmission fees are incurred even when a substitute image or Chara-den is displayed during a
video-phone call.
Set speed when dialing Redial voicecall Dialing order
64K
ON 64K
→
32K
→
Voice call
OFF 64K
→
32K
32K
ON 32K
→
Voice call
OFF 32K
dv22̲e.book Page 76 Monday, February 14, 2005 4:58 PM