Foma SH700i, Manual

Page: 500 / 588

498
Da
ta
Com
m
uni
c
a
tio
n
[M]: AT commands that can be used with the FOMA SH700i Modem Port.
AT Command List
AT Command Overview Parameter/Explanation
Execution
Example
AT%V
[M]
Displays FOMA terminal
version.
*2
—
AT%V
o
Ver1.00
OK
AT&C<n>
[M]
Sets operating condition for
signals sent from circuit CD
(DCD) to DTE.
*1
n=0: Circuit CD always ON
n=1: Circuit CD signal changes according to
line connection status (default setting)
When “&C1” is set, the CD signal is turned
“ON” directly before the CONNECT signal is
sent when connection is completed. The CD
signal is turned “OFF” right before “NO
CARRIER” is sent when the circuit is
disconnected.
AT&C1
o
OK
AT&D<n>
[M]
Sets mode of terminal when a
signal received from DTE
changes the circuit ER (DTR)
mode from “ON” to “OFF”
during online data mode.
*1
n=0: Ignore status (always consider signal
ON)
n=1: Set online command mode when
signal changes from ON to OFF
n=2: Disconnects line and activates offline
mode when signal changes from ON to
OFF (default setting)
AT&D1
o
OK
AT&E<n>
[M]
Selects speed display
specifications when
connecting.
*1
n=0: Wireless area transmission speed
appears.
n=1: DTE serial transmission speed
appears. (Default setting)
AT&E0
o
OK
AT&F<n>
[M]
Resets the FOMA terminal’s
AT command settings to their
values at time of factory
shipment. If this command is
entered during
communication, the line is
disconnected before settings
are reset.
*2
Can only be set as n=0 (may be omitted). AT&F
o
OK
AT&S<n>
[M]
Controls when the signal of
data set ready (DR) is set to
DTE.
*1
n=0: Always ON (default setting)
n=1: DR signal ON when line is connected AT&S0
o
OK
AT&W<n>
[M]
Stores the current settings in
the FOMA terminal’s
memory.
*2, *5
Can only be set as n=0 (may be omitted). AT&W
o
OK
AT
*
DANTE
[M]
Displays number of antennas
on TE.
*2
The result from this command is in the
following format.
*
DANTE:<m>
<m>
0: Status where outside the service area
appears on the FOMA terminal
1: Status where one antenna appears on
the FOMA terminal
2: Status where two antennas appears on
the FOMA terminal
3: Status where three antennas appears on
the FOMA terminal.
AT
*
DANTE
o
*
DANTE:3
OK
AT
*
DGANSM=
<n>
[M]
Sets Accept/Reject call
modes for incoming packet
communications. This setting
is only valid for incoming
packet communications after
entering setup commands.
*2
n=0: Set Reject call and Accept call settings
to OFF (Default setting)
n=1: Set Reject call settings ON
n=2: Set Accept call settings ON
AT
*
DGANSM=0
o
OK
AT
*
DGANSM?
o
*
DGANSM:0
OK
dv22̲e.book Page 498 Monday, February 14, 2005 4:58 PM