Foma SH700i, Manual

Page: 497 / 588

495
Da
ta
Com
m
uni
c
a
tio
n
J
Disconnecting
Simply closing the browser may not
disconnect the connection. Follow the steps
below to properly disconnect.
The FOMA terminal has OBEX as a data communication
protocol. OBEX data communication enables sending and
receiving phonebook, owner information from the Own
number screen, schedules, ToDo list, sent mail (including
SMS), received mail (including SMS), unsent mail (including
SMS), text memos, melodies, my picture, i-motion, and
bookmark data to and from a PC. The FOMA SH700i is
also equipped with an Ir exchange function. Send and
receive phonebook entries or data from received mail to/
from other FOMA terminals also equipped with the Ir
exchange function. Sending and receiving data (for
Melody, My picture, i-motion) to/from a PC using cable
connection is not supported. Data transfer via miniSD
Memory Card is necessary. (
n
P. 549)
Use the following three types of data communication
with the FOMA terminal.
Send data one item at a time, from a PC to a FOMA
terminal (Write 1).
Send data in bulk, from a PC to a FOMA terminal
(Write all).
Send data in bulk, from a FOMA terminal to a PC
(Read all).
Send data one item at a time, from a FOMA
terminal to a PC (Read 1).
During data communication, the handset will be
outside the service area, and functions such as
i-mode, i-mode mail, voice/video-phone call, and
packet transmission will not be available.
Even after completion of data communication,
A
(out
of service area) may be displayed for a short time.
J
Devices required for data
communication (OBEX)
To perform data communication, downloading OBEX-
compliant data transfer software from the Internet
(
n
P. 549), and installing this software to your PC is
necessary. Refer to the software manual for
information on operating environment and installation
methods. In addition, installation of the FOMA SH700i
Communication setting file (
n
P. 471 to P. 473) is
necessary beforehand.
A FOMA USB cable is required to connect the FOMA
terminal to a PC.
1
Double click in the task tray
and click
切断
(Disconnect).
The connection is disconnected.
Sending and Receiving
Data (OBEX)
Sending/Receiving FOMA
Terminal Data to/from a PC
Note
Make sure the FOMA terminal is properly
connected to the PC. If not connected properly,
sending and receiving data may not be possible, or
data may be lost.
Fully charge the FOMA terminal and check
whether there is enough remaining battery power.
If data communication is performed when the
battery level is low or empty, sending and receiving
data may not be possible, or data may be lost.
Performing operations while charging the FOMA
terminal in the desktop holder is recommended.
Note
Check the PC power supply as well. If not turned
on, sending and receiving data may not be
possible, or data may be lost.
Perform data communication with the FOMA in
stand-by.
During communication (voice/video-phone call, and
data communication) data cannot be sent or
received. Also, when sending and receiving data,
other data communication cannot be performed.
However, receiving a call, right after data
communication has begun, may be possible. In such
cases, the sending or receiving of data is canceled.
FOMA card phonebook data cannot be sent or
received.
During Ir exchange, melodies, still pictures, or
i-motion files that are prohibited from being
attached to mail or being sent outside the FOMA
terminal to a PC cannot be sent. However, still
pictures and movies shot with the built-in camera
can be sent even if file restrictions are set to
Restricted .
Mail with melody (MFi) data attached, i-motion mail
before i-motion acquisition, and mail with i-
α
ppli
start up designations can be sent after attached
data has been deleted.
Attached JPEG images 10,001 bytes or more or
500 KB or less are deleted and mail is sent.
Data such as phonebook data cannot be
transmitted while All lock (
n
P. 146), PIM lock
(
n
P. 150), or Self mode (
n
P. 149) is set.
Phonebook data cannot be sent or received when
Keypad dial lock (
n
P. 151) is set.
Depending on data size, data communication may
take some time. In addition, the FOMA terminal
may not be able to receive data due to data size.
When receiving phonebook data, data will be
added from memory number
010 for single entries,
or in accordance with memory number information
when receiving all entries.
When receiving all phonebook entries, Owner
information (excluding first phone number)
registered in Own number will be overwritten.
Phonebook entries are sent in memory number order.
When sending all phonebook entries, Owner
information from own number screen is also sent.
Note
The FOMA terminal data communication function
(OBEX) conforms with IrMC1.1. However,
depending on the application, some data may not
be sent or received even when the other party’s
terminal complies with IrMC1.1.
dv22̲e.book Page 495 Monday, February 14, 2005 4:58 PM