Foma P702i, Manual

Page: 469 / 478

31
5
The connection is completed.
After the connection is completed, the message below appears from
the indicator of the task bar for a few seconds.
p You can start the browser software to browse web pages, use
e-mail and so on.
p If this message does not appear, confirm the setting of the access
point name again.
1
Click the dial-up icon on
the task tray.
2
Click “ 切断 (Disconnect)”.
information
p
Use the FOMA phone with the dial-up setting completed for dial-up
connection. To connect another FOMA phone, you may need to
reinstall the communication setup files.
p
The power consumption of the FOMA phone increases during
communication.
p During packet communication, the communication state appears on the
FOMA phone.
“ ” (Communicating, data sending)
“ ” (Communicating, data receiving)
“ ” (Communicating, no data sending/receiving)
“ ” (Outgoing or being disconnected)
“ ” (Incoming or being disconnected)
p During 64K data communication, “ ” appears on the FOMA phone.
Disconnecting
information
p The communication line may not be disconnected by only exiting the
browser software. To surely disconnect the communication line,
perform this operation.
p The baud rate displayed on your personal computer may be different
from the actual one.
If you cannot connect to network (if you fail a dial-up
connection), confirm the following items:
The operation below explains how to set the 64K data
communication without using “FOMA PC setup
software”.
The setting of dial-up connection and TCP/IP for the 64K
data communication is the same as for the packet
communication (see page 19).
Take care of the following points:
p In the 64K data communication, you do not need to specify an
access point name (APN). For the access point of the dial-up
connection, enter the phone number of the access point specified by
your Internet service provider or network administrator. (To connect
to mopera U, enter “
_ 8701” in the phone number field. To connect to
mopera, enter “ _ 9601” in the phone number field.)
p
Set “caller ID notified/not notified” and “others” as required.
(When connecting to mopera U or mopera, you need to notify the
access point of your caller ID.)
p
Contact your Internet service provider or network administrator for
details on the setting contents.
You can connect and disconnect the 64K data
communication in the same way as for the packet
communication. Perform the operations shown on page
15 and page 30.
When you cannot Connect to Network
If this error occurs Confirm those:
Your personal
computer cannot
recognize “FOMA
P702i”
･
Confirm whether your personal computer satisfies
the operating environment (see page 1).
･ Confirm whether the P702i communication setup
file is installed in your personal computer.
･ Confirm whether the FOMA phone is connected to
your personal computer and powered on.
･ Confirm whether the FOMA USB Cable (option) is
securely connected.
You cannot connect
to the access point ･ Confirm whether the ID (user name) and password
are correct.
･
When you need to notify the access point of your
caller ID such as when using mopera U or mopera,
make sure “184” is not prefixed to the phone
number.
･ Confirm that “ フロー制御を使う (Use the flow
control)” is checked in the modem properties.
･ If you cannot connect to the access point even
after confirming above, consult your Internet
service provider or network administrator about the
setting method.
Setting 64K Data Communication
Setting Dial-up Connection and TCP/IP
How to Connect and Disconnect