3
Silo
Temporary storage place for abrasive. You can fill the silo without stopping the ADS. During a vessel
fill cycle, abrasive moves from the silo through a pinch valve, and then into the vessel.
4
Silo low-abrasive switch
If this switch does not sense abrasive, the yellow warning indicator flashes continuously and the
audible signal sounds in a rhythmic pattern. Also, the display panel shows the
Silo Empty
notice.
5
Control panel
The control cabinet contains the PLC, which monitors operating conditions and sends control signals
to the solenoid valves, the yellow warning indicator, and the audible signal.
6
Vessel low-abrasive switch
If this switch does not sense abrasive for 20 seconds, the yellow warning indicator illuminates
continuously and the audible signal sounds continuously. Also, the display panel shows the Vessel
Empty notice. In FlowCUT, the part program stops and a message is displayed.
7
Vessel
After a vessel fill cycle, the vessel is pressurized and pushes the abrasive through a hose to the
machine’s abrasive metering valve.
8
Pinch valve pneumatic
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: PASER CF900 Abrasive Delivery System
Summary of Contents for MACH 300
Page 1: ...MACH 300 SYSTEM MANUAL Includes Ancillary Options M 810 REV C en APRIL 2021...
Page 28: ...View 2 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 29: ...View 3 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 107: ...ANCILLARY OPTIONS For Mach 300...