![background image](http://html1.mh-extra.com/html/flow/mach-300/mach-300_manual_2307753123.webp)
Set up UltraPierce in FlowCUT
To set up the device in FlowCut, do the following:
1. Go to
Setup
>
Jet
. In the dialog box, select
Pierce First
.
2. Under
Pierce
routine, choose a routine.
3. Under
Vacuum
control, choose an option.
4. Under
ON procedure
, enter the time (in seconds) of each dwell, and then select
Abrasive on
first, then jet on
to minimize delamination.
5. Under
OFF
procedure, enter the time (in seconds) of each dwell.
6. In the
Pierce time
box, enter the length of time.
7. Select
Save as Default
or
OK
.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: UltraPierce Vacuum Assist
Summary of Contents for MACH 300
Page 1: ...MACH 300 SYSTEM MANUAL Includes Ancillary Options M 810 REV C en APRIL 2021...
Page 28: ...View 2 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 29: ...View 3 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 107: ...ANCILLARY OPTIONS For Mach 300...