Analyze cut parts to identify the source of an issue
After you cut a high-precision part, do a quick inspection of the part to indicate the source of a potential
problem.
Sloped parallelogram
If the cross section of a rectangular part renders as a sloped parallelogram, the cutting head did not
home in a vertical position.
Curved sides
If the top view of a rectangular part shows curved sides with the same curve at the top and bottom of
the cut, then either the standoff or calibration are incorrect.
Kickback marks
If all the process settings are correct and the inside corners have kickback marks, decrease the
corner speed in the Corner Control Model.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 13, 2021 PST
Cutting with Dynamic Waterjet
Summary of Contents for MACH 300
Page 1: ...MACH 300 SYSTEM MANUAL Includes Ancillary Options M 810 REV C en APRIL 2021...
Page 28: ...View 2 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 29: ...View 3 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 107: ...ANCILLARY OPTIONS For Mach 300...