Inspect the mixing tube
Where used
Mach 500 · Mach 300 · Mach 200 · Mach 100
Recommended maintenance interval
Daily
Summary
Inspect your mixing tube daily so you can monitor and limit ID growth. Note that the mixing tube is
brittle carbide. Do not bend, drop, or twist it Replace the mixing tube if it shows any of the following
conditions:
• Prominent, off-center wear at the nozzle exit tip ID.
• Chips in the downstream end, outside edge of the nozzle that originate at the outside diameter
and leave less than 0.020 in. (0.508 mm) nozzle wall thickness.
• Cracks that extend radially from the nozzle ID to OD, or that extend down the length of the
nozzle.
• Chips in either end of the nozzle that originate at the inside diameter.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 15, 2021 PST
Cutting head maintenance
Summary of Contents for MACH 300
Page 1: ...MACH 300 SYSTEM MANUAL Includes Ancillary Options M 810 REV C en APRIL 2021...
Page 28: ...View 2 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 29: ...View 3 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 107: ...ANCILLARY OPTIONS For Mach 300...