Adjust the cutting head spacing
To adjust and set the cutting head spacing, use the locking knob and ruler. Manually tighten the locking
knob. Do not use tools. To maximize material usage, spacing should be set slightly larger than the parts
being cut or to an even multiple of the part size. The offset to the head centerline (5 cm) is noted on the
cutting head carriage for easy reference.
Note that the tubing may be slightly stiff, so not all positions on the spreader are available. If it resists
being adjusted, don’t force it. Allow the tubing to relax, tighten the fittings, and then slide to the desired
position on the spreader bar. Otherwise, it will be harder to get a good, leak-tight connection.
WARNING!
Do not adjust the cutting head spacing until after the system is depressurized.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 13, 2021 PST
Cutting with a spreader bar
Summary of Contents for MACH 300
Page 1: ...MACH 300 SYSTEM MANUAL Includes Ancillary Options M 810 REV C en APRIL 2021...
Page 28: ...View 2 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 29: ...View 3 2021 Flow International Corp Retrieved from Flow KB on April 12 2021 PST Safety...
Page 107: ...ANCILLARY OPTIONS For Mach 300...