$80$6)0ROAND$80($-)3ERIESs/PERATION
18
Powering On
!PPLYPOWERBYCONNECTINGTHEPROVIDED)%#POWERCORDTOTHEREARPANEL)%#CONNECTOR
and to an AC source. The switcher performs a self-test that flashes the front panel
button indicators red, green, and amber and then turns them off. An error-free power-up
self-test sequence leaves all I/O and control buttons either unlit or showing background
ILLUMINATION4HELITORUNLITSTATUSOFTHE6IDEOAND!UDIOBUTTONSREMAINSTHESAMEASIT
was when the switcher was previously powered off.
4HECURRENTCONlGURATION%$)$INFORMATIONANDALLPRESETSARESAVEDINMEMORY7HEN
power is applied, the most recent configuration is retrieved. The previous presets remain
intact.
If an error occurs during the self-test, the DXP locks up and does not operate. If this
OCCURSCALLTHE%XTRON33ALES4ECHNICAL3UPPORT(OTLINESEETHEREARCOVERFOR
contact
information
in your area).
Creating a Configuration
A configuration consists of one or more inputs, each tied to a set of one or more outputs.
NOTE:
7HILEANINPUTCANBETIEDTOMULTIPLEOUTPUTSANOUTPUTCANBETIEDTOONLY
one input.
This section contains the steps to follow to create or change a configuration. The following
subsections contain some examples of configurations that can be created on the DXP,
and instructions for setting them up. The illustrations show the DXP 88; however, the
procedures apply to all DXP models.
To create a configuration:
1.
0RESSTHE%SC
>
button to clear any input, output, or control button indicators that
may be lit.
2.
Select to configure video, audio, or both by pressing the
6IDEOAND!UDIOBUTTONS
h
and
i
in figure 10
).
3.
Select the desired input and outputs by pressing the input and output buttons
(
a
and
b
in figure 10
).
s
The input buttons light one of the following colors:
s
Amber:
6IDEOANDAUDIOTIES
s
Green:
6IDEOONLYTIES
s
Red:
Audio only ties
s
Output buttons light or blink one of the following colors:
s
Amber:
6IDEOANDAUDIOTIES
s
Green:
6IDEOONLYTIES
s
Red:
Audio only ties
s
To indicate
potential ties
, output buttons
blink
in the appropriate color when an
input is selected.
s
To indicate
current ties
, output buttons
light
steadily
in the appropriate color
when an input is selected.
s
To clear unwanted outputs, press and release the associated lit output buttons. To
indicate
potential unties
, output buttons
blink
the appropriate color when an
output is deselected (muted) but not untied from the input.
