Extreme Networks Summit X150 Series, Hardware Installation Manual

Page: 387 / 512

Removing a Summit X460 Series Switch
Summit Family Switches Hardware Installation Guide
387
Removing a Summit X460 DC Power Supply
To remove an installed Summit X460 DC power supply:
1 De-energize the DC circuit.
2 Disconnect the DC power cables as follows:
a Slide the cover off the terminal block.
b Loosen the screws that secure the cable terminals to the terminal block.
c Slide the wires out from under the captive washers.
3 Disconnect the ground wire as follows:
a Remove the screw that secures the ground wire to the power supply.
b Move the wire away from the power supply.
4 Push the latching tab to the left as you pull outward on the handle to disengage the power supply
internal connectors (see
Figure 326 ).
Figure 326: Removing a Summit X460 DC Power Supply
5 Carefully slide the power supply the rest of the way out of the switch.
Removing the Summit X460 Series Switch from the Rack
To remove a Summit X460 series switch from the equipment rack:
1 Verify that the power supplies have been removed from the switch.
2 Support the switch as you remove the screws that hold the switch to the rack.
3 Slide the switch out of the rack.
SH_212